MG 1974-75 SPECIFICATIONS AND ADJUSTMENTS
TIRE INFLATION (COLD)
Before attempting to check or adjust wheel alignment, make sure tires are properly inflated. Refer to manufacturers specifications in owner's manual.
CASTER
All Models - Caster is nonadjustable. If alignment not within specifications, inspect for damage suspension parts and repair or replace as necessary.
CAMBER
All Models - Camber is not adjustable. If alignment is not within specifications, inspect suspension parts for wear or damage and repair or replace components as necessary
TOE-IN
All Models - Turn front wheels to straight-ahead position and check toe-in measurement. Move vehicle ahead so front wheels rotate 180 degrees and take second reading. Take average of two reading to check toe-in. If not within specifications, loosen lock nut for each tie rod and loosen clips, securing rubber gaiters to tie rods. To adjust, rotate both tie rods equally to set toe-in to specifications. NOTE - Tie rods must be equal lengths. Tighten lock nuts and clips on tie rods.
1974
1975
